Prediction of tool-chip contact length based on slip-line modeling of orthogonal cutting with rounded-edge cutting tools

Abstract

It is known that no cutting tool has a perfectly sharp cutting edge and that there is always a small rounding on the cutting edge of the tool. In this study, a new tool-chip contact length equation is presented for cutting tools with rounded-edge in orthogonal cutting. This equation was obtained based on a newly developed slip-line model. This newly developed slip-line model has rounded-edge cutting and considers the presence of a dead metal zone in front of the cutting edge. To verify the newly developed tool-chip contact length equation, experimental studies were conducted at various cutting speeds and uncut chip thickness values at both 0° and 6° rake angles, using cutting tools with 50 μm–100 μm–150 μm edge radii. Orthogonal cutting experiments were carried out using the shaping-based quick stop device and brass (CuZn30) material was chosen as a workpiece that allows continuous chip formation without built-up edge. Strong correlation was observed between the experiment results and values that were obtained from the newly developed tool-chip contact length equation.

Keywords:

• Cutting edge radius
• orthogonal cutting
• slip-line model
• tool–chip contact length

Disclosure statement

No potential competing interest was reported by the author(s).