Effect of multipass friction stir processing on microstructure and mechanical properties of MIG welded joints of AA6082 and AA7075

Abstract

Metal inert gas (MIG) welding is widely employed for aluminum alloy welding, but high residual stress, coarse grain’s structure, porosity, and micro-cracks occur during MIG welding. To avoid these defects, friction stir processing (FSP) was employed to the MIG welded joints of AA7075 and AA6082 with ER4043 filler. The grain structure of the weld fusion zone (WFZ) was categorized by eutectic precipitated Mg₂Si, and primary α-Al. The elongated, coarse grain structure of the MIG weldment decreased after a one pass FSP. The Mg₂Si precipitates were disseminated due to the enhancement of dispersion and dissimilar metal fraternization. The fraction area of the refined grains increases when the FSP pass increases. Furthermore, the effective enhancement of the joint efficiency was observed in the MIG + 4Pass FSP due to the grain refinement. The ultimate tensile strength (UTS) of 169.73 MPa of the MIG welded joint was observed with a grain size of 17.9 ± 0.3, while the highest UTS of 223.84 MPa was perceived at 4 passes of MIG + FSP joints with an elongation of 12.45%. The grain structure was also refined as the FSP pass increased, and the minimum grain size (2.6 ± 0.3 µm) was perceived at MIG + 4Pass FSP. Multipass FSP leads to refinement and homogenization of the microstructure, increasing the microhardness of the weldment. The average hardness value of the MIG weldments at the WFZ was 84 HV, while the microhardness of MIG + FSP joints of 1Pass, 2Pass, 3Pass, and 4Pass FSP was 88, 96, 101, and 110 HV at the stir zone (SZ).

Keywords:

• Tensile strength
• microstructure
• multipass FSP
• tensile strength
• hardness

Author contribution

Vinay Kumar: Data curation, writing original draft preparation, and paper writing

Vipin: Editing and reviewing

R.S. Mishra: Visualization, and editing

Disclosure statement

No potential conflict of interest was reported by the author(s).