283
Views
53
CrossRef citations to date
0
Altmetric
Original Articles

Sources of Hydrocarbon Emissions from Low-Temperature Premixed Compression Ignition Combustion from a Common Rail Direct Injection Diesel Engine

, &
Pages 496-517 | Received 01 Aug 2007, Accepted 30 Sep 2008, Published online: 09 Jun 2010
 

Abstract

Low-temperature premixed compression ignition combustion (PCI) discussed in this study is achieved via late injection timing (close to top dead center) and heavy exhaust gas recirculation (EGR) using ultra low sulfur Swedish diesel fuel (sulfur content less than 15 ppm). PCI obtains a simultaneous decrease in particulate matter (PM) and oxides of nitrogen (NOx), as where injection timing is retarded, as opposed to conventional combustion, where a PM-NOx trade-off is observed. In PCI, hydrocarbon (HC) and carbon monoxide (CO) are increased, and must be removed using aftertreatment. In order to understand the sources of HC from the PCI regime, gas chromatography with a flame ionization detector is employed to perform exhaust HC speciation at three EGR rates and three injection timings. Volatile HC, semi-volatile HC, and CO increase as the injection timing is retarded or EGR is increased. Retarded injection timing or increased EGR reduces peak cylinder bulk temperature and thereby increases the yield of CO and volatile HC (mostly C1–C3). Retarded injection timing or increased EGR also increases ignition delay, which increases over-mixing and causes more mixture to become so lean that combustion ceases and the output of semi-volatile HC species (mostly unburned C10–C12 fuel) is increased. Volatile HC species are increased more than semi-volatile HC species, which results in a shift to a lighter exhaust HC mixture as injection timing is retarded or EGR is increased.

The authors are thankful for the technical and financial support provided by the General Motors Collaborative Research Laboratory at the University of Michigan.

Notes

∗ASTM D1319 method.

Refer to Table 4 for specific operating conditions.

Abbreviations: M = methyl, DM = dimethyl, TM = trimethyl, E = ethyl, DE = diethyl.

For the fuel analysis, the GC-2 is used: split ratio 20:1, total flow = 27 ml/min, column flow = 1.2 ml/min, oven temperature profiles: 40°C for 5 min, 6°/min for 43.33 min, 300°C for 0 min; FID = 300°C, injection port = 250°C.

0.1 µl fuel diluted in n-hexane (dilution ratio 10:1) injected into GC-2 injection port.

Abbreviations: M = methyl, DM = dimethyl, TM = trimethyl, E = ethyl, DE = diethyl.

Reprints and Corporate Permissions

Please note: Selecting permissions does not provide access to the full text of the article, please see our help page How do I view content?

To request a reprint or corporate permissions for this article, please click on the relevant link below:

Academic Permissions

Please note: Selecting permissions does not provide access to the full text of the article, please see our help page How do I view content?

Obtain permissions instantly via Rightslink by clicking on the button below:

If you are unable to obtain permissions via Rightslink, please complete and submit this Permissions form. For more information, please visit our Permissions help page.