On-line compensation of dead-time and inverter nonlinearity with disturbance voltage observer

Abstract

This paper discusses and analyses a simple on-line compensation scheme for dead-time and inverter nonlinearity in the pulse width modulated (PWM) voltage source inverter (VSI). Dead-time effect and voltage drop in switching devices cause nonlinearity between reference and output voltage. In a conventional three-phase six-switch inverter, this nonideal condition adds extraneous harmonics that badly disturb voltage characteristics. In its turn, voltage disturbance causes distortion of the current waveform and degrades performance. In this paper, an on-line dead-time compensation method based on inverse dynamics control is proposed, and it is much simpler than conventional full/reduced order observation methods adopted in dead-time compensation. Disturbance voltages are observed on-line with no additional circuitry or off-line measurements. The observed disturbance voltages are fed back to the voltage reference for compensation. Stability problem of the proposed observer arisen from inverter delay and parameter mismatch was analysed. The proposed method is applied to a surface-mounted permanent-magnet synchronous motor (SPMSM) drive. The effectiveness of the proposed scheme is validated by the experimental results.

Keywords:

• dead-time
• disturbance observer
• estimation
• inverter
• permanent-magnet synchronous machine (PMSM)

View correction statement:

Corrigendum

Acknowledgement

This study was supported by research fund from Chosun University, 2012.