1
Views
0
CrossRef citations to date
0
Altmetric
Original Articles

The Effects of Crystal Size, Iodide Content and Iodide Distribution on the Covering Power and Rate of Development at Dmax of Sensitized, Cubic Monosize Emulsions in ID2 and ID11 DevelopersFootnote

Pages 198-202 | Received 13 Jun 1976, Published online: 22 Jul 2016
 

Abstract

Covering powers at, and rates of development of, Dmax for various sensitised emulsions have been determined after various times of development in two metol/hydroquinone developers, ID2 or ID11.

Application of the analysis of variance technique yielded the following conclusions:

(a) covering power

(i) is inversely related to crystal size

(ii) tends to decrease with increasing development

(iii) depends upon iodide content and

(iv) does not differ significantly, on average, between the two developers.

(b) ID2 developer acts more quickly than IDI1

(c) small crystals develop more quickly than large crystals

(d) iodide content has no effect on development rate up to 1.6 mole per cent but 6 mole per cent or more reduces the developability.

The limited results for iodide-layer emulsions indicate that it is the presence of iodide at the crystal surface which reduces developability. The data can be satisfactorily explained using the following ideas:

ID11 acts more slowly than ID2 and produces more solution physical development; small crystals develop faster than large crystals and produce more solution physical development; the presence of iodide reduces the amount of solution physical development and partial development of large crystals in IDI 1 gives higher covering power than full development.

Resume

Le pouvoir couvrant à Dmax d'émulsions diversement sensibilisées, ainsi que leur developpabilité, ont été déterminés en fonction de la durée de développement dans deux révélateurs metol/hydroquinone, c.g. ID2 et 1D11.

Une analyse de variance conduit aux résultats suivants:

(a) pouvoir couvrant

—est inversement proportionnel à la dimension des cristaux —tend à décroître avec l’augmentation de la durée de développement —dépend du contenu en iodure —ne diffère pas, en moyenne, d’un révélateur à l'autre

(b) le révélateur 1D2 est plus actif que 1D11

(c) les petits cristaux se développent plus rapidement que les gros.

(d) le contenu en iodure n’a pas d’effet sur la vitesse de développement jusqu’à 1,6 mole pour cent; 6 mole pour cent ou plus provoque une diminution de la développabilité

Les résultats limités obtenus pour les émulsions contenant de 1’ iodure indiquen! que c’est la présence d’iodure à la surface des cristaux qui diminue la développabilité. Les valeurs obtenues sont interprétées de la manière suivante: le révélaleur IDI 1 agit plus lentement que ID2 et donne lieu à plus de développement physique, les petits cristaux se développement plus rapidement que les gros et donnent lieu à plus de développement physique; en présence d’iodure, le développement physique est réduit, le développement partiel des gros cristaux dans IDI I conduit à un pouvoir couvrant plus élevé que celui d’un développement total.

Zusammenfassung

Deckkraft und Prozentsatz des entwickelten Silbers in Dmax von verschiedenen sensibilisierten Emulsionen wurden ln zwei Metol/Hydrochlnon Entwicklern, ID2 und IDI I, als Funktion der Entwicklungszeiten bestimmt.

Mittels Varianzanalyse konnten folgende Schlüsse gezogen werden:

(a) Die Deckkraft

(I) ist umgekehrt proportional zur Kristallgrösse

(11) nimmt mit fortschreitender Entwicklung ab

(III) hängt vom Iodidgehalt der Emulsion ab und

(IV) unterscheidet sich im Mittel nicht für die beiden Entwickler

(b) Der Entwickler ID2 wirkt schneller als IDI 1

(c) Kleine Kristalle werden schneller entwickelt als grosse und

(d) Iodidgehalte bis zu 1.6% beeinflussen die entwickelte Silbermenge nicht, lodidgehalte über 6% hingegen reduzieren die

Entwickelbarkeit.

Einige Resultate für schichtweise aufgebaute Emulsionskrislalle lassen vermuten, dass nur das sich an der Oberfläche befindliche lodid die Entwickelbarkeit reduziert.

Eine befriedigende Interpretation der Daten ergibt sich aus folgenden Annahmen:

IDI1 wirkt langsamer als ID2 und bewirkt mehr physikalische Entwicklung; kleine Kristalle werden schneller entwickelt als grosse Kristalle und ergeben mehr physikalische Entwicklung; Präsenz von lodid reduziert die physikalische Entwicklung: Teilcntwicklung von grossen Kristallen führt in IDI 1 zu höherer Deckkraft als die vollständige Entwicklung.

Riassunto

Potere coprente e percentuale dell’argento sviluppato alla densità massima sono stati determinati per diverse emulsioni sensibilizzata a diversi tempi di sviluppo nei due sviluppatori al metolo-idrochinone ID2 e IDI 1.

Applicando la tecnica dell’analisi della variabiliti si giunge alle seguenti conclusioni:

(a) potere coprente

I—e inversamente proporsionale alla dimensione dei cristalli

II—tende a diminuire con l’incremento dello sviluppo

III—dispende dal contenuto in ioduri

IV—non differisce in modo significativo nei due sviluppatori

(b) lo svillupatore IB2 agisce più rapidamente dell’IDI I

(c) i piccoli cristalli si svillupano più rapidamente dei grandi

(d) un contenuto in ioduri sino a 1.6 mol% non ha effetto sulla quantità di argento svillupata ma oltre 6 mol% provoca una

riduzione della sviluppalità.

Alcuni risultati riguardanti emulsioni con cristalli a superficie iodata indicano che è la presenza di ioduno sulla superficie del cristallo che riduce la sviluppabilità.

Una soddisfacente spiegazione si ponò avere con il seguente ragionamento:

lo sviluppatore IDI 1 è più lento dclllD2 e agisce maggiormente come sviluppo fisico i piccoli cristalli si sviluppano più rapidamente dei grandi e favoriscono lo sviluppo fisico, la presenza di ioduro riduce l’azione come sviluppo fisico; uno sviluppo parziale dei grossi cristalli nellTDI I fornisce un potere coprente maggiore che lo sviluppo a fondo.

Notes

Paper presented at a symposium on Fundamental problems in Photographic Science organized by the Science Committee of The Royal Photographic Society on 10-13 September 1975 in Oxford.

Reprints and Corporate Permissions

Please note: Selecting permissions does not provide access to the full text of the article, please see our help page How do I view content?

To request a reprint or corporate permissions for this article, please click on the relevant link below:

Academic Permissions

Please note: Selecting permissions does not provide access to the full text of the article, please see our help page How do I view content?

Obtain permissions instantly via Rightslink by clicking on the button below:

If you are unable to obtain permissions via Rightslink, please complete and submit this Permissions form. For more information, please visit our Permissions help page.