Article title: Binary gas diffusivity estimates from transient, one-dimensional sublimation–diffusion experiments in a spherical enclosure
Authors: Jeylisse Castañer and Carlos A. Ramírez
Journal: Chemical Engineering Communications
Bibliometrics: Volume 205, Number 9, pages 1167–1192
DOI: https://doi.org/10.1080/00986445.2018.1437033
Publisher: Taylor & Francis
In the above article, published in issue 205(9) of Chemical Engineering Communications, a number of editorial corrections are needed. In order of appearance, they are:
“Thus, the accuracy of all Sh correlations developed through the years has depended, among other things, on careful experimental measurements of mass loss from a surface with time, knowledge of DAB, and careful statistical analysis…,” should have appeared as: “Thus, the accuracy of all Sh correlations developed through the years has depended, among other things, on careful experimental measurements of mass loss from a surface with time, knowledge of DAB, and detailed statistical analysis…” (p. 1168).
“…and (d) incorporation as a sublimating, pore-formation filler in pressed tablet formulations aimed at rapid disintegration and drug dissolution in the mouth…,” should have appeared as: “…and (d) incorporation as a sublimating, pore-forming filler in pressed tablet formulations aimed at rapid disintegration and drug dissolution in the mouth…” (p. 1171).
“This is consistent with the best-known DAB estimation models which are based on the corresponding states theory…,” should have appeared as: “This is consistent with the best-known DAB estimation models which are based on the corresponding-states theory…” (p. 1172).
“Several estimation procedures for DAB in binary gaseous systems have been reported, the most reliable being the corresponding state methods…,” should have appeared as: “Several estimation procedures for DAB in binary gaseous systems have been reported, the most reliable being the corresponding-states methods…” (p. 1176).
“All laboratory safety procedures pertaining to handling and…,” should have appeared as: “All laboratory safety procedures pertaining to the handling and…” (p. 1179).
“…model VWR 320 SP35825, Barnstead/Thermolyne Corporation, Dubuque, IA…,” should have appeared as: “…model VWR 320 SP35825, Barnstead/Thermolyne Corporation, Dubuque, IA, USA…” (p. 1179).
The text “…outside dimensions: 24 cm long ×7.1 cm wide × 2 cm high…” was incorrectly broken into two paragraphs, with the break appearing after the second “×”. It should have appeared as a single line without the break (p. 1179).
“A chi-square goodness of fit test…,” should have appeared as “A chi-square goodness-of-fit test…” (p. 1184).