A STUDY OF SILICONE OIL-IN-WATER EMULSIONS

Abstract

Emulsions of silicone oil-in water were formed using a Brinkmann Polytron homogenizer with Igepal CO-530 as an emulsifier. Silicone viscosities ranged from 10 to 33,000 mPa.s at 25°C. Rheological characteristics and particle size analyses of silicone oil-in-water emulsions were studied. At high volume fraction of the dispersed phase (70%-75%), silicone oil-in-water emulsions were stable. At lower volume fractions (50%-60%), emulsions formed were less stable and the two phases easily separated in a few days. The emulsions formed with high volume fraction silicone oil show highly non-Newtonian behavior (shear thinning). Emulsions made with low viscosity oils had lower viscosities than those made from high viscosity oils. Relative viscosity-concentration data could be correlated by the Frankel and Acrivos Equation. Increasing the emulsifier concentration of 70% oil-in-water emulsions resulted in a decrease in mean droplet size and an increase in emulsion viscosity. Increasing the intensity of agitation also resulted in higher viscosity and smaller droplet size until a critical energy input above which droplet size increased. Emulsification with low shear mixing provides more control in decreasing mean droplet size with time.

Keywords:

• Emulsions
• silicone oil-in-water
• intensity of agitation
• droplet size
• theology of emulsions
• oil volume fraction effect

Additional information

Notes on contributors

BRAM A. SAADEVANDI

Present address: Department of Chemical Engineering, West Virginia University, Morgan-town, WV 26506.

JACQUES L. ZAKIN

To whom all correspondence should be addressed.