Fabrication and Characterization of Functional Fiber Based on Polymethacrylate/Polypropylene Alloy via in situ Compatibilization

Abstract

A poly(butyl methacrylate) (PBMA)/polypropylene (PP) blended fiber was prepared via reactive extrusion and melt spinning based upon the mechanism of in situ compatibilization, and its capacity to absorb organic liquid, gel fraction and remaining ratio were investigated. In addition, the miscibility between PBMA and PP, crystallization behavior and morphology of the blended fiber were characterized. The results indicate the blended fiber can absorb a certain amount of liquid, such as toluene, chloroform, and trichloroethylene, etc., and its absorption capacity gradually weakens and even disappears with increasing the mass fraction of PP in the mixture of PBMA and PP. The results obtained by thermogravimetric (TG) analysis show the miscibility between PBMA and PP becomes better due to an increase of the interactions between two phases under the effect of in situ compatibilization reaction, and the blended fiber has relatively better thermal stability with an increase in the mass fraction of PP. X-ray diffraction (XRD) results demonstrate the additional amount of PP has a significant impact on its crystallization capacity for the blended fiber, along with in situ compatibilization reaction. The results observed via field emission scanning electron microscope (FESEM) reveal that PP can efficiently improve the spinnability of PBMA, and endow the blended fiber with a near-optimal morphology. However, in situ compatibilization reaction also has a marked influence on the surface and cross-section morphology of the blended fiber.

Keywords:

• Blended fiber
• In situ compatibilization
• Melt spinning
• Polymethacrylate
• Polypropylene
• Reactive extrusion

Notes

Color versions of one or more of the figures in the article can be found online at www.tandfonline.com/lpte.