ABSTRACT
Passive seismic approaches, using a single-station, enable rapid, cost-effective and non-invasive estimates of the thickness of sedimentary rocks overlying crystalline basement. This approach was applied to estimate the Cenozoic and Cretaceous succession beneath the Nullarbor Plain in southeastern Western Australia. Passive seismic data acquired at the majority of the 94 sites show a single, strong resonance frequency peak between 0.4 and 0.6 Hz suggesting an impedance contrast of a single subsurface layer. Modelling these resonance frequencies against known stratigraphy at 12 drill holes shows that this impedance contrast corresponds to the contact of the base of the Cenozoic–Cretaceous sedimentary succession of the Eucla and Bight basins with the crystalline basement. Data from the remaining sites produced sediment thickness estimates ranging from only tens of metres near the western edge of the Nullarbor Plain to over 860 m near its southern margin. Near this margin, rapid thickening of the sedimentary cover is coincident with an interpreted paleosea-cliff or indicative of localised faulting. Beneath the Western Australian portion of the Nullarbor Plain the sedimentary cover is on average 320 m thick with the succession thinning gradually towards the margins of the basin. A passive seismic approach is thus seen as a useful screening tool for the mineral exploration industry in areas that are under cover allowing for better targeting and cost-reduction in greenfields exploration.
Editorial handling:
Acknowledgements
The authors would like to thank the reviewers for their useful suggestions and edits on the manuscript. Acknowledgements are also due to Adam Symonds for his support and assistance during fieldwork and drafting of figures. This article is published with the permission of the Director of the Geological Survey of Western Australia.
Disclosure statement
No potential conflict of interest was reported by the authors.
Supplementary Paper
Appendix A: Processed HVSR plots (traces) of passive seismic data for all sites within the study area. All data are based on 20-minute acquisitions (unless otherwise indicated). Corresponding site locations are listed in Raw data is also freely available for download via MAGIX accessible via the Department of Mines and Petroleum's online portal GeoView (HYPERLINK “https://protect-us.mimecast.com/s/LL62BWsLqEgpCK?domain=dmp.wa.gov.au” www.dmp.wa.gov.au). Data of this study is listed under Government ground geophysics survey 71107.