Elevated Temperature Evaluation of Fretting and Metal Transfer between Coated Titanium Components

Abstract

During fretting, small amplitude displacements and high normal surface loads combined with abrasive oxide particles cause surface damage that acts as initiation sites for fatigue cracks. Since these conditions are prevalent within the titanium dovetail joints of jet engines a wear mode analysis was performed on extended service jet engine disks and compressor blades. The results of the wear mode analysis indicated that titanium from the uncoated disk was transferred to the softer copper-nickel-indium coated dovetail surface of the blades. This transfer created titanium on titanium contact and eventually fretting wear. In order to simulate these conditions, a moderate displacement (125 μm), low cycle phase followed by a small displacement (25 μm), high cycle fretting phase utilizing a cylinder on flat configuration was developed. The analysis and test procedure developed during this study will ultimately aid in the selection and evaluation of a new coating capable of preventing fretting.

Presented at the 54th Annual Meeting Las Vegas, Nevada May 23–27, 1999

KEY WORDS:

• Fretting
• Wear
• Dovetail
• Titanium
• Coatings

Notes

Presented at the 54th Annual Meeting Las Vegas, Nevada May 23–27, 1999