Physical and Tribological Properties Degradation of Silicone Rubber Using Jatropha Biolubricant

ABSTRACT

This article aims to investigate the degradation of physical and tribological properties (friction coefficients and wear resistance) of a dynamic sealing material (silicone rubber [VMQ]) exposed to Jatropha oil (JO), engine mineral oil (EMO), and a blend (B20; 80% EMO–20% JO), separately. JO has demonstrated better lubricating properties than EMO in various mechanical applications; however, the degradation of elastomers by using this oil has not been studied yet, nor have its effect on their tribological properties. The physical degradation was evaluated by conducting static immersion tests (670 h at 25 °C) based on ASTM-D471 and ASTM-D7216 methods. Hence, the changes in mass, volume, tensile and tear strengths, and hardness of VMQ were measured. In addition, creep compliance tests were conducted to determine the changes in viscoelastic properties and the changes in morphology and topography were measured by scanning electron microscopy (SEM) and optical profilometry, respectively. In addition, the compositional changes were determined by Fourier transform infrared (FTIR) analyses to complement the degradation examination. Changes in the friction coefficients were determined by ball-on-disk tests and changes in wear resistance were obtained by accelerated wear tests (microabrasion tests). Finally, VMQ exhibited no significant physical and compositional degradation due to immersion in the three lubricants. However, considerable changes in the friction coefficients and wear resistance were observed; the change in the friction coefficients was minimal using JO. In addition, the coefficients using JO were 50% lower than those for EMO and the changes in wear resistance were lowest after immersion in JO.

KEYWORDS:

• Vegetable oils
• friction
• silicon
• elastomers
• infrared
• wear

Acknowledgments

We thank “Grupo de Mecánica Fractal” from IPN-SEPI ESIME Zacatenco and “Laboratorio de Reología y Física de la Materia Blanda” from IPN-ESFM for allowing us to use their laboratories and for their assistance. We also appreciate the support of CNMN-IPN in the chemical and SEM analyses of our samples.