Evolutionary Algorithm for Vehicle Driving Cycle Generation

ABSTRACT

Modeling transit bus emissions and fuel economy requires a large amount of experimental data over wide ranges of operational conditions. Chassis dynamometer tests are typically performed using representative driving cycles defined based on vehicle instantaneous speed as sequences of “microtrips”, which are intervals between consecutive vehicle stops. Overall significant parameters of the driving cycle, such as average speed, stops per mile, kinetic intensity, and others, are used as independent variables in the modeling process. Performing tests at all the necessary combinations of parameters is expensive and time consuming. In this paper, a methodology is proposed for building driving cycles at prescribed independent variable values using experimental data through the concatenation of “microtrips” isolated from a limited number of standard chassis dynamometer test cycles. The selection of the adequate “microtrips” is achieved through a customized evolutionary algorithm. The genetic representation uses microtrip definitions as genes. Specific mutation, crossover, and karyotype alteration operators have been defined. The Roulette-Wheel selection technique with elitist strategy drives the optimization process, which consists of minimizing the errors to desired overall cycle parameters. This utility is part of the Integrated Bus Information System developed at West Virginia University.

IMPLICATIONS

It is expected that the paper will provide a useful tool for modeling and analysis of vehicle fuel economy and emissions and for the design, optimization, and analysis of driving cycles for testing and vehicle fleet management.

ACKNOWLEDGMENTS

This research effort was sponsored by the Federal Transit Administration through grant WV-26-7008.