Effect of thermal shock process on the microstructure and peel resistance of single–sided copper clad laminates used in waste printed circuit boards

ABSTRACT

Efficient pre-processing is essential to the mechanical recovery of waste printed circuit boards (WPCBs). In this work, a thermal shock pretreatment was utilized to damage the interface between metals and nonmetals of single-sided copper clad laminates (SSCCLs), which are usually employed as the base material of printed circuit boards (PCBs). The effects of three thermal shock treatment parameters—i.e., peak temperature, holding time, and thermal shock cycle times—on the adhesion strength of SSCCLs were evaluated by orthogonal experiments. Microstructures and peel resistance of SSCCLs before and after thermal shock were characterized by scanning electron microscopy (SEM) and 90° peel test, respectively. Our results showed that the impact of three major factors that influence liberation efficiency was in the sequence of peak temperature > shock cycle times > holding time. Furthermore, the optimal thermal shock level could be achieved when the peak temperature was 300°C with the soaking time of 30 min and three cycle times. In the meantime, the corresponding peel strength of the SSCCLs (0.065 N/mm) was sharply decreased by 94% in comparison with those without thermal shock treatment. The manual dismantling experimental data verified the good feasibility of the optimal thermal shock process, suggesting that the copper foil could be readily dismantled from the substrate by hand after pretreatment, with a successful separation rate of 100% and a peeling efficiency of ~ 30 seconds per piece. Therefore, the optimal thermal shock process could notably improve liberation of metals and nonmetals, which would be helpful for efficient recycling of WPCBs.

Implications: The interface between copper foil and laminate dielectric in a PCB can be weakened significantly via efficient thermal shock method. Thus, a good liberation could be achieved after thermal shock. In this work, a manual peeling of copper foil from the SSCCL substrates was achieved efficiently after optimal thermal shock pretreatment, confirming the feasibility of a shorter process of metal recovery from scrap SSCCLs without pulverization. The results will be useful for the pretreatment of recovery of the WPCBs.

Additional information

Funding

The authors would like to acknowledge the financial support from the Guangdong - Major Scientific Research Program of Higher Education of Guangdong (2016KQNCX189) and Social Science and Technology Development Project of Dongguan (2017507154411).

Notes on contributors

Fangfang Liu

Fangfang Liu is a Ph.D. student at the Guangdong Key Laboratory for Advanced Metallic Materials Processing, South China University of Technology, in Guangzhou, People’s Republic of China, and a lecturer at Dongguan University of Science and Technology, in Dongguan, People’s Republic of China.

Bingbing Wan

Bingbing Wan is a postdoctoral researcher at the School of Materials Science and Engineering, Dongguan University of Technology, Dongguan, People’s Republic of China.

Fazhan Wang

Fazhan Wang is a master’s student at the Guangdong Key Laboratory for Advanced Metallic Materials Processing, South China University of Technology, Guangzhou, People’s Republic of China.

Weiping Chen

Weiping Chen is a distinguished professor at Guangdong Key Laboratory for Advanced Metallic Materials Processing, South China University of Technology, Guangzhou, People’s Republic of China.