Microstructure, hardness, toughness and abrasive wear resistance of 16.0 wt. % chromium white iron after continuous and cyclic destabilisation treatment

Abstract

Destabilisation of as-cast chromium white iron with 16 wt-% chromium are performed by continuous destabilisation treatment for 4 h and short duration (0.66 h) cyclic destabilisation treatment at 900, 950, 1000, 1050, and 1100 °C. Continuous destabilisation causes secondary carbides precipitation from austenite which on slow cooling transforms to pearlite matrix. Cyclic destabilisation treatment causes similar precipitation of finer secondary carbides following shorter period austenitisation and a matrix containing martensite and retained austenite on forced-air cooling. After continuous destabilisation, hardness falls below the as-cast value (HV622); whereas it rises to HV950 after cyclic destabilisation treatment. The as-cast notched impact toughness (4.0 J) increases to 8.5 J or more after both continuous and cyclic destabilisation at 1050 and 1100 °C. Abrasive wear resistance after continuous destabilisation improves only at higher wear load (49.0 N), while after cyclic destabilisation it supersedes the as-cast and Ni-Hard IV performance at both low (19.6 N) and high (49.9 N) wear load.

Keywords:

• Chromium white iron
• microstructure
• hardness
• impact toughness
• wear resistance