Subsurface damage in alumina and alumina–silicon carbide nanocomposites

Abstract

The subsurface plastic deformation below alumina (Al₂O₃) and Al₂O₃–silicon carbide (SiC) nanocomposite surfaces subjected to grinding, polishing and annealing has been measured by high-resolution grazing-incidence parallel-beam X-ray powder diffraction and transmission electron microscopy. The variation with angle in the full width at half-height maximum (FWHM) of the X-ray Bragg peaks was successfully modelled by a FWHM distribution that fell exponentially with increasing depth. Consistent parameters were extracted from data taken using both prism and pyramidal reflecting planes. Correlation was found between the depth at which the FWHM fell to 1/e of the surface value and the depth of damage observed by transmission electron microscopy. The associated surface strain in the nanocomposite was found to increase linearly with increasing diameter of the diamond polishing particles. In ground 5 vol.% SiC nanocomposite, these random surface strains fell by a factor of 7 and the depth of damage increased by a factor of 3 after annealing at 1250°C for 2 h. No differences were observed in the Bragg peak FWHM as a function of angle for material polished with 1 µm diamond grit before and after annealing.

Acknowledgements

Financial support from the Engineering and Physical Sciences Research Council is acknowledged. We are grateful to Andy Fitch and the team on ESRF beam line BM16 for the excellent support given to us during the experiments.

Notes

| Present address: School of Engineering, Coventry University, Priory Street, Coventry CV1 5FB, UK.

Additional information

Notes on contributors

T. P. A. Hase

| Present address: School of Engineering, Coventry University, Priory Street, Coventry CV1 5FB, UK.