On the refinement of carbide precipitates by cryotreatment in AISI D2 steel

Abstract

Refinement of carbide particles by cryotreatment is often proposed as a major factor for the improvement of wear resistance in tool steels. However, this proposition is not substantiated by experimental evidence. This has been examined in this report by (i) detailed micro-structural analyses of the nature, volume fraction, size, population density and distribution of carbide particles, (ii) XRD and EDX micro-analysis on the bulk samples and electrochemically extracted carbides, and (iii) measurement of hardness and wear rate of a series of differently cryotreated AISI D2 steel. The results conclusively establish that (i) cryotreatment, in comparison to conventional treatment, induces precipitation of finer carbides with higher volume fraction and more uniform distribution, and (ii) population density and the size of secondary carbide particles significantly increases with holding time up to a critical duration at 77 K in cryotreatment. The latter observation indicates the pioneering direction towards optimization of cryotreatment design for techno-economic benefit.

Keywords:

• cryogenic treatment
• AISI D2 steel
• carbide precipitation
• retained austenite
• wear

Acknowledgments

Financial assistance from the University Grants Commission, Government of India [Grant no. F. No. 31-48/2005(SR)] to carry out part of this research is gratefully acknowledged.