Precipitation in solution-treated aluminium–4 wt% copper under cyclic strain

Abstract

Solution-treated Al–4 wt% Cu was strain-cycled at ambient temperature and above, and the precipitation and deformation behaviours investigated by TEM. Anomalously rapid growth of precipitates appears to have been facilitated by a vacancy super-saturation generated by cyclic strain and the presence of continually refreshed dislocation density to provide heterogeneous nucleation sites. Crystallographic texture appears to be responsible for latent hardening in specimens tested at room temperature. Increasing temperatures lead to a gradual hardening throughout life due to precipitation. Specimens machined at 45° from the rolling direction, which exhibit rapid precipitation hardening, show greater texture hardening due to increased axial stress required to cut precipitates in specimens. In the temperature range 100–200°C, precipitation of Θ″ is suppressed by cyclic strain, and precipitation of Θ′ promoted. The rapid growth of precipitates generated by cyclic strain operates with diminishing effect at higher temperatures due to faster recovery of non-equilibrium vacancy concentrations. Θ′ precipitates generated under cyclic strain are smaller and more finely dispersed than those produced via quench-ageing due to heterogeneous nucleation on dislocations and possess a low aspect ratio and rounded edges of the broad faces caused by the introduction of ledges into the growing precipitates by dislocation cutting. Frequency effects indicate that dislocation action is responsible for the observed reduction in aspect ratio. Accelerated formation of grain-boundary precipitates appears partially responsible for rapid inter-granular fatigue failure at elevated temperatures, resulting in coexistent fatigue striations and ductile dimples on the fracture surface.

Keywords:

• precipitation
• aluminium alloys
• cyclic strain
• texture
• vacancies
• strain-assisted precipitation

Acknowledgements

The authors gratefully acknowledge the provision of the study alloy by Alcoa, and the generosity of Drexel University for the use of the OIM system. This work was performed at the Laboratory for Research of the Structure of Matter at the University of Pennsylvania with generous support from the Los Alamos National Laboratory. The excellent support of Dr Alex Radin in mechanical testing and of other colleagues in the Department of Materials Science and Engineering is also gratefully acknowledged.