Strain incompatibility and its influence on grain coarsening during cyclic deformation of ARB copper

Abstract

It is well known that the characteristic length scale in ultra-fine grained and nanocrystalline metals has a significant effect on the mechanical behaviour. The inhibited ability to accommodate imposed strain with conventional dislocation mechanism has led to the activation of unconventional deformation mechanisms. For one, grain coarsening at shear bands has been observed to occur within metals with sub-micron grain size upon cyclic deformation. Such grain coarsening is often linked to the observed cyclic softening behaviour. The purpose of this study was to investigate the relationship between strain localisation associated with shear banding and the observed deformation-induced grain coarsening in ultra-fine grained metals. The investigation was carried out using ultra-fine grained, oxygen-free high conductivity copper processed by accumulative roll-bonding. A close relationship between strain localisation and deformation-induced grain coarsening was revealed. As strain localisation is not only found at shear bands, but also at other places whereby heterogeneous microstructure or geometric discontinuity is present, hence the present study bears a general significance. Such strain localisation sites may also include a hard constituent embedded in a relatively ductile matrix, micro-crack tips and artificial notches. The stress concentration at these sites provides a high input of strain energy for grain boundary motion leading to grain coarsening. Furthermore, when the grain size is very small, the stress gradient leading away from the stress concentration sites is also believed to increase the driving force for grain boundary migration within the affected regions.

Keywords:

• accumulative roll-bonding
• cyclic deformation
• grain coarsening
• strain localisation
• deformation incompatibility

Acknowledgements

The authors express their gratitude for the ARBed copper sheets provided by Dr. S.B. Kang, Dr. C.Y. Lim and Dr. H.W. Kim of Korean Institute of Materials Science. The authors would also like to acknowledge Dr. Patrick Woo and Hitachi High Technologies Canada for access to their equipment. This project was funded by the Natural Sciences and Engineering Research Council of Canada (NSERC).