Abstract
This study investigated the effect of high flow conditions on aerosol penetration and the relationship between penetration at constant and cyclic flow conditions. National Institute for Occupational Safety and Health (NIOSH)-approved N95 and P100 filtering facepiece respirators and cartridges were challenged with inert solid and oil aerosols. A combination of monodisperse aerosol and size-specific aerosol measurement equipment allowed count-based penetration measurement of particles with nominal diameters ranging from 0.02 to 2.9 μm. Three constant flow conditions (85, 270, and 360 L/min) were selected to match the minute, inhalation mean, and inhalation peak flows of the four cyclic flow conditions (40, 85, 115, and 135 L/min) tested. As expected, penetration was found to increase under increased constant and cyclic flow conditions. The most penetrating particle size (MPPS) generally ranged from 0.05 to 0.2 μm for P100 filters and was approximately 0.05 μm for N95 filters. Although penetration increased at the high flow conditions, the MPPS was relatively unaffected by flow. Of the constant flows tested, the flows equivalent to cyclic inhalation mean and peak flows best approximated the penetration measurements of the corresponding cyclic flows.
ACKNOWLEDGMENTS
The authors would like to thank the Office of Law Enforcement Standards, National Institute of Standards and Technology, Gaithersburg, Md., and the National Personal Protective Technology Laboratory (NPPTL), National Institute for Occupational Safety and Health, Pittsburgh, Pa., for supporting this project. Special appreciation goes to Dr. Samy Rengasamy, NPPTL, for his expertise and assistance with planning this study.