Asbestos fiber length and width comparison between manual and semi-automated measurements

Abstract

The objective of the present study is to find a fast and accurate procedure to measure the length and width of asbestos fibers using images acquired by a scanning electron microscope (SEM), a phase-contrast microscope (PCM), and a polarized light microscope (PLM). The accuracy of the procedure was evaluated by comparing fiber length and width measurements to manual measurements. Four different types of images were used in the evaluation: (1) backscattered electron SEM images of fibrous tremolite, (2) secondary electron SEM images of fibrous grunerite, (3) PCM images of fibrous grunerite, and (4) PLM images of fibrous grunerite. Fiber length and width were measured with ImageJ (manual measurement) and Image-Pro software and were compared on an individual fiber basis and over the number-length and number-width distribution of each sample. The results of the comparison showed that the individual length and width measurements with ImageJ and Image-Pro software had a nearly 1:1 relationship except for the width measurement in PLM images (8% of the variance in ImageJ width measurements was not explained by Image-Pro width measurements). Similarly, the number-length distributions were not significantly different (p > 0.05) between ImageJ and Image-Pro, but the number-width distributions were significantly different (p < 0.05) for PLM and secondary electron SEM images. Although the image analysis procedure for measuring fiber length and width with Image-Pro is not a fully automated procedure and still requires some manual intervention, it can be a more efficient and equally accurate alternative to time-consuming manual fiber length and width measurements for well dispersed fibers with high aspect ratios.

Keywords:

• Asbestos
• image analysis
• ImageJ
• Image-Pro

Disclaimer

The findings and conclusions in this report are those of the authors and do not necessarily represent the official position of the National Institute for Occupational Safety and Health, Centers for Disease Control and Prevention. Mention of any company or product does not constitute endorsement by NIOSH.

Additional information

Funding

National Institute for Occupational Safety and Health, Project #9390BMJ: Understanding elongate mineral particle exposure in mining.