48
Views
0
CrossRef citations to date
0
Altmetric
Research Article

Determination of the optimum biogas energy ratio in dual-fuel biodiesel used in cooking oil-biogas operation

, ORCID Icon, , & ORCID Icon
Pages 13001-13020 | Received 24 Apr 2023, Accepted 28 Oct 2023, Published online: 17 Nov 2023
 

ABSTRACT

This study aims to examine the effects of biogas input ratio on the engine performance, combustion characteristics, and emissions of dual-fuel mode diesel engines fueled by waste cooking oil biodiesel combined with biogas. The engine test was carried out in dual-fuel mode biodiesel-biogas operation with variations in the methane content of the biogas and biogas energy ratio in excess of 90%. The methane gas content was varied from 40%, 60%, 80%, and 100% with different applied loads. A constant engine speed of 2400 rpm is used for all tests. It has been shown that increasing the methane content of the biogas can improve the brake thermal efficiency, particularly at high loads. A maximum brake thermal efficiency of 29.3% can be achieved on dual fuel with 100% methane gas content. This value has increased by 7.51% compared to biodiesel fuel under the same load conditions. Biogas with 100% methane gas also reaches cylinder pressures of 8.07 MPa and rate of heat release of 35.8 J/deg-1 at high load operation. This study confirmed that the use of biogas with more than 90% biogas energy ratio can be operated in a dual fuel mode. At low and medium loads, nitrous oxide emissions are drastically reduced at biogas energy ratios of up to 90%, 82.8%, and 65.1%, respectively. The study also identified the optimum biogas energy ratio operating range of 60–90% for maximum thermal efficiency and low emissions.

Nomenclature

GHG=

Greenhouse gas

WCO=

Waste cooking oil

HC=

Hydrocarbons emission

CO=

Carbon monoxide emission

CO2=

Carbon dioxide emission

NO=

Nitric oxide

PM=

Particulate matter

CH4=

Methane

CH3OH=

Methanol

CR=

Compression ratio

DFM=

Dual fuel mode

SFM=

Single fuel mode

BTE=

Brake thermal efficiency

BG60M=

Biogas contains 60% methane gas and 40% CO2 gas

BG70M=

Biogas contains 70% methane gas and 30% CO2 gas

BER=

Biogas energy ratio

M40=

Biogas contains 40% methane gas and 60% CO2 gas

M60=

Biogas contains 60% methane gas and 40% CO2 gas

M80=

Biogas contains 80% methane gas and 20% CO2 gas

M100=

Biogas contains 100% methane gas

COVmaxp=

Coefficient of variation at maximum pressure

HP=

Horsepower

ATDC=

At top dead center

ROHR=

rate of heat release

Acknowledgements

We thank Robert Ireland, PhD, from Edanz (https://jp.edanz.com/ac) for editing a draft of this manuscript. This work was supported by f3 Engineering Education and Research Center, Faculty of Engineering, Hokkaido University

Disclosure statement

No potential conflict of interest was reported by the author(s).

Additional information

Notes on contributors

Iman Kasih Telaumbanua

Iman Kasih Telaumbanua Conceptualization, Data analysis, Writing – original draft.

Yoshihiko Oishi

Yoshihiko Oishi, Conceptualization, Methodology, Project administration, Writing – original draft.

Daichi Ogawa

Daichi Ogawa, Methodology, Data analysis, Writing – original draft.

Hideki Kawai

Hideki Kawai, Funding acquisition, Conceptualization, Supervision, Writing – review and editing.

Himsar Ambarita

Himsar Ambarita Conceptualization, Supervision, Writing – review and editing.

Reprints and Corporate Permissions

Please note: Selecting permissions does not provide access to the full text of the article, please see our help page How do I view content?

To request a reprint or corporate permissions for this article, please click on the relevant link below:

Academic Permissions

Please note: Selecting permissions does not provide access to the full text of the article, please see our help page How do I view content?

Obtain permissions instantly via Rightslink by clicking on the button below:

If you are unable to obtain permissions via Rightslink, please complete and submit this Permissions form. For more information, please visit our Permissions help page.