Condition monitoring of a diesel engine fueled with a blend of diesel, biodiesel, and butanol using engine oil analysis

Abstract

Conditioning monitoring is constantly helpful in scheduling maintenance activity and deciding the oil drain period for engines to ascertain the highest performance. Conditioning monitoring assures increased availability, higher design efficiency, and reduced maintenance cost. In the present work, experiments were performed on two identical single-cylinder engines by running them for 144 hours at a constant speed of 1500 rpm. The first engine was fueled with butanol blended fuel and the second with neat diesel fuel. Three samples of engine oil from each engine were collected after 48, 96, and 144 hours respectively. The engine oil (multigrade servo 20W-40) samples were examined to determine the condition of the engine by two methods: wear metal analysis; and physical and chemical tests. The wear metal analysis was monitored by the ICE 3000 series atomic absorption spectrometer. The viscosity was measured using the Anton Paar Rheolab QC rheometer at a constant speed of 1200 rpm and 40 °C temperature and the total acid number was measured by the titration method. The metal wear, total acid number, and viscosity in the butanol-fueled engine were slightly greater than those of the diesel-fueled engine.

Keywords:

• condition monitoring
• atomic absorption spectroscopy
• oil analysis
• wear
• total acid number

Acknowledgements

The authors wish to thank to the Uttarakhand Council of Science & Technology for their funding to carry out this work. The authors would also like to thank Dr S.J. Chopra (Chancellor UPES) for encouragement and blessings. The authors are also thankful to Dr Shyam Pandey for the opportunity to be a part of this project.

Disclosure statement

No potential conflict of interest was reported by the authors.

Additional information

Funding

Uttarakhand Council of Science & Technology supported this research [grant number UCS&T/R&D/PHY SC.-05/11-12/4336/1].