![Sample our Engineering & Technology journals, sign in here to start your access, latest two full volumes FREE to you for 14 days]({"type":"image" , "src" : "/sda/5933/TOC-Subject-Sample-2021-Engineering-Tech.jpg"})
Abstract
The Gas Tungsten Arc Welding (GTAW) process is frequently used in welding of aluminum alloys, because of its possible heat input control. This control can be utilized through a good selection of the process variables, which in turn results in optimizing the bead dimensions. The object of this investigation was to study the effect of TIG process parameters on weld bead dimensions. Suitable combinations of tungsten electrode parameters and process variables can lead to optimum GTAW bead dimensions. With alternative current (AC) polarity, a weld bead may be formed between two 3-mm thick pieces of 5005 aluminum–magnesium alloy sheets. The effect of electrode diameter, vertex angle, and the welding current and speed on the bead dimensions were investigated. Results revealed that the rate of increase of bead width with current increase is greater than that produced by decreasing travel speed, and means that the bead width can be controlled more efficiently by welding current rather than by welding speed. For example, bead width can be reduced by half by increasing the welding travel speed three times, whereas it can be doubled when the current has is doubled. In contrast, bead depth is found to be more sensitive to welding speed rather than to the welding current. One of the important results of the present investigation was that the average heat-affected zone width decreased as the welding current and/or speed increased. On the other hand, it was found that the influences of electrode diameter and apex angle on the bead width were similar to their effects on the arc size. The bead width was found to decrease with an increase in the electrode diameter to a certain extent, and increase slightly with an increase of the apex angle.
