In Vitro Study of Transdermal Nicotine Delivery: Influence of Rate-Controlling Membranes and Adhesives

Abstract

The objective of this study was to evaluate the influence of a rate-controlling membrane and adhesive on the in vitro permeation of nicotine. The physicochemical properties of the adhesive, including adhesion and rheology (viscosity), were also detected. Higher permeability of nicotine was observed through a hydrophilic membrane than through a hydrophobic membrane. Natural rubber and silicone were used as the adhesive bases, respectively. The silicone adhesive showed the highest adhesion among all adhesive formulations. To increase the adhesion of natural rubber, a tackifier (polyisoprene) and a secondary tackifier (terpene polymer; Px 1150®) were incorporated into the formulations to achieve acceptable adhesion. The nicotine permeation through silicone adhesive and three natural rubber adhesives with the secondary tackifier (2%, 4%, and 6% Px 1150) was close to that from a commercially available patch (Habitrol®), although the loading amount of nicotine was not the same. A longer lag time during the in vitro permeation study of nicotine was required for the adhesives prepared in our laboratory than for the commercially available patch.