Surface analysis and printability studies on electron beam-irradiated thermoplastic elastomeric films from LDPE and EVA blends

Abstract

The electron beam-initiated surface modification of films prepared from various blends of low-density polyethylene (LDPE), ethylene vinyl acetate (EVA), and ditrimethylol propane tetraacrylate (DTMPTA) was carried out over a range of radiation doses (20-500 kGy) and concentrations of DTMPTA. The films were characterized by Fourier transform infrared-attenuated total reflectance (FT-ATR) spectroscopy, X-ray photoelectron spectroscopy (XPS), scanning electron microscopy (SEM), contact angle measurements, and peel adhesion. The printability of the films was also measured. FT-ATR and XPS revealed that the surface polarity of the films made from a 50 : 50 blend of LDPE and EVA increased up to a radiation dose of 100 kGy, compared with the unirradiated sample. The polarity decreased after 100 kGy radiation. Surface pitting and roughness were observed in the SEM photomicrographs of the same films, irradiated at higher radiation doses. Higher values of the surface energy were obtained at 100 kGy for the samples without DTMPTA and for the samples containing 3 wt% DTMPTA. Excellent printability was observed for all the films irradiated above an irradiation dose of 20 kGy. The data on the printability and peel adhesion of the irradiated films could be explained by surface energy, XPS, and SEM results.

Keywords:

• LOW-DENSITY POLYETHYLENE
• ETHYLENE VINYL ACETATE
• DITRIMETHYLOL PROPANE TETRAACRYLATE
• ELECTRON BEAM
• MORPHOLOGY
• XPS
• SURFACE ENERGY
• PEEL ADHESION
• PRINTABILITY