Effect of compaction pressure and powder grade on microstructure and hardness of steam oxidised sintered iron

Abstract

Steam oxidation has proven to be an effective process to improve the properties of sintered iron components. The oxide formed on the surface and in the interconnected porosity strongly influences both the tribological and mechanical properties of these materials, for example through the extent of pore closure and the nature and morphology of the oxide produced. In this paper, the influences of compaction pressure and powder size on the microstructure, oxide content, hardness, and surface topography of steam treated sintered iron are analysed. Specimens prepared from atomised iron powders of different sizes (<65, 65–90, 90–125, and >125 µm) were compacted at four different pressures (300, 400, 500, and 600 MPa), sintered for 30 min at 1120°C and then subjected to a continuous steam treatment at 540°C for 2 h. A clear influence of the processing parameters on porosity was highlighted. Low porosity was always associated with high compaction pressure and greater powder size. Pore size was affected in the same way by compaction pressure, even though the effect of powder size acted in the opposite sense. Changes in compaction pressure and powder size had no significant effect on pore shape. Decreasing powder size always led to high hardness. The effect of compaction pressure on hardness is clear evidence of a compromise between porosity and blockage of the pore network by oxide. Samples produced with smaller powder sizes showed a continuous decrease in hardness as the compaction pressure increased, although for the large powder size there was a slight increase to a constant value of ultimate hardness. For the intermediate powder size a maximum hardness was obtained as the compaction pressure increased. X-ray diffraction showed that the oxide layer is composed of magnetite and haematite.