Metal powder compacting dies: optimised design by analytical or numerical methods

Abstract

The initial data needed to design metal powder compaction die are: compact shape and density, powder mix composition, compaction and radial pressure, part number and tool materials. The design targets are: diameters of insert and ring, sometimes number of rings and interference or interferences. The constraints include: no tensile stresses on the insert, no risk of relative motion at part ejection, no unwanted alteration of material microstructures and maximum stresses always below the allowable limits. Usually the design is based on engineering experience, company knowhow, and approximated analytical calculations and cost considerations.

This study is focused on the use of numerical methods to determine the design parameters of dies for powder compaction. Both room temperature and warm compaction have been investigated. Numerical algorithms, implemented into FEM calculation codes, enable one to optimise the common diameter of insert and ring, corresponding to the lowest stresses on both items, or to find the minimum value of the outer diameter. A wide range of compaction pressures, die materials and geometries, interferences and allowable stresses have been explored. To compare the results, based either on analytical or numerical methods, circular dies have been investigated. The differences among the results depend on the consideration of the actual stressed length, or compact height, and total die length. The calculations by analytical methods overestimate the stresses. The paper presents some suitable nomograms for the comparison of results of calculations performed either by Laméformulas or by sophisticated numerical methods.