Extrusion characteristics of aluminium alloy/SiC_pmetal matrix composites

Abstract

Systematic extrusion studies have been carried out on aluminium alloy 2124/SiC_p metal matrix composites. Effects of various extrusion process parameters, such as die design, ram speed, extrusion ratio, reheat temperature, and lubrication, on the pressure requirement and surface quality of the as extruded circular rods have been investigated. Different volume fractions of SiC particles (10, 15, and 20 vol.-%) were used for the synthesis of metal matrix composite billets. These composites were synthesised using two different techniques, namely, stir casting and powder metallurgy. These billets were then hot extruded on a laboratory scale 500 ton vertical hydraulic press. The significance of specially designed dish shaped dies, avoiding the dead metal zone, has also been highlighted. The results indicated that the best extrusion was possible when powder metallurgical processed billets were extruded. Volume fraction analysis of ceramic reinforcement in the extruded rod (typically 2 m long) and in the extruded discard showed no appreciable backward migration of these particles during extrusion.