Tribological properties of composite multilayer coating

Abstract

The use of surface coatings is emerging as one of the most important approaches in reducing friction and wear in various tribological applications. Even though single layer coatings have a wide range of applications, the performance of the single layer alone may not always be adequate to meet the desired tribological property requirements. Hence, coatings consisting of multilayers to meet different property requirements in demanding applications are required. In this study, the tribological properties of a graded composite multilayer coating, with a specific layer sequence of MoS₂/Ti–MoS₂/TiBN–TiBN–TiB₂–Ti deposited on tool steel substrate, have been investigated at temperatures of 40 and 400°C respectively. The experimental results from the tests at 40°C have shown that the friction coefficient value ranges between 0·02 and 0·034. It was found that the deposition parameters influenced the friction and durability of the coatings. Higher substrate bias was found to result in higher friction, and the coating deposited at high substrate bias and low N₂ flow showed the lowest durability. The friction coefficient and durability of the coatings were found to be highly dependent on temperature. At high temperature, the friction coefficient increases almost threefold, and the durability decreases significantly.

Keywords:

• Composite multilayer coating
• High temperature
• Friction and wear

This research has been funded by the Swedish Research Council, and the authors gratefully acknowledge their support. SSAB Oxelösund in Sweden is also acknowledged for contributing the material for test specimens and taking keen interest in the research.