Overdenture retaining bar stress distribution: A finite-element analysis

Abstract

Objective. Evaluate the stress distribution on the peri-implant bone tissue and prosthetic components of bar-clip retaining systems for overdentures presenting different implant inclinations, vertical misfit and framework material. Materials and methods. Three-dimensional models of a jaw and an overdenture retained by two implants and a bar-clip attachment were modeled using specific software (SolidWorks 2010). The studied variables were: latero-lateral inclination of one implant (–10°, –5°, 0°, +5°, +10°); vertical misfit on the other implant (50, 100, 200 µm); and framework material (Au type IV, Ag-Pd, Ti cp, Co-Cr). Solid models were imported into mechanical simulation software (ANSYS Workbench 11). All nodes on the bone’s external surface were constrained and a displacement was applied to simulate the settling of the framework on the ill-fitted component. Von Mises stress for the prosthetic components and maximum principal stress to the bone tissue were evaluated. Results. The +10° inclination presented the worst biomechanical behavior, promoting the highest stress values on the bar framework and peri-implant bone tissue. The –5° group presented the lowest stress values on the prosthetic components and the lowest stress value on peri-implant bone tissue was observed in –10°. Increased vertical misfit caused an increase on the stress values in all evaluated structures. Stiffer framework materials caused a considerable stress increase in the framework itself, prosthetic screw of the fitted component and peri-implant bone tissue. Conclusions. Inclination of one implant associated with vertical misfit caused a relevant effect on the stress distribution in bar-clip retained overdentures. Different framework materials promoted increased levels of stress in all the evaluated structures.

Key Words:

• finite element analysis
• implant inclination
• misfit
• overdenture

Acknowledgements

To Foundation for Research Support of the State of Sao Paulo (FAPESP Grant # 2011-16463-4) for the assistance to Master Degree Program at Piracicaba Dental School, State University of Campinas, SP, Brazil.

Declaration of interest: The authors report no conflicts of interest. The authors alone are responsible for the content and writing of the paper.