Characterization of a new cutinase from Thermobifida alba for PET-surface hydrolysis

Abstract

A new cutinase from Thermobifida alba (Tha_Cut1) was cloned and characterized for polyethylene terephthalate (PET) hydrolysis. Tha_Cut1 showed a high degree of identity to a T. cellulolysitica cutinase with only four amino acid differences outside the active site area, according to modeling data. Yet, Tha_Cut1 was more active in terms of PET surface hydrolysis leading to considerable improvement in hydrophilicity quantified based on a decrease of the water contact angle from 87.7° to 45.0°. The introduction of new carboxyl groups was confirmed and measured after esterification with the fluorescent reagent alkyl bromide, 2-(bromomethyl) naphthalene (BrNP), resulting in a fluorescence emission intensity increase from 980 to 1420 a.u. On the soluble model substrates p-nitrophenyl acetate (PNPA) and p-nitrophenyl butyrate (PNPB), the cutinase showed Km values of 213 and 1933 μM and k_cat values of 2.72 and 6.03 s⁻¹ respectively. The substrate specificity was investigated with bis(benzoyloxyethyl)terephthalate (3PET) and Tha_Cut1 was shown to release primarily 2-hydroxyethyl benzoate. This contrasts with the well-studied Humicula insolens cutinase which preferentially liberates terminal benzoic acid from 3PET.

Keywords::

• Thermobifida alba
• PET
• 3PET
• cutinase

Acknowledgements

This study was performed within the Austrian Centre of Industrial Biotechnology ACIB, the MacroFun project and COST Action 868. This work has been supported by the Federal Ministry of Economy, Family and Youth (BMWFJ), the Federal Ministry of Traffic, Innovation and Technology (bmvit), the Styrian Business Promotion Agency SFG, the Standortagentur Tirol and ZIT - Technology Agency of the City of Vienna through the COMET-Funding Program managed by the Austrian Research Promotion Agency FFG.

Declaration of interest: The authors report no conflicts of interest. The authors alone are responsiblefor the content and writing of the paper.