Selection for Electron Microscopy of Specific Areas in Large Epoxy Tissue Sections

Abstract

Tissue blocks 2 × 2 × 0.4 cm were fixed 6-24 hr in phosphate-buffered 6% glutaraldehyde then sliced to 2 × 2 × 0.1 cm and rinsed in phosphate buffer for at least 12 hr. Fixation was continued for 2 hr in phosphate-buffered 1-2% OsO₄. The slices were dehydrated, infiltrated with Araldite, and embedded in flat-bottomed plastic molds. Sectioning at 4-8 μ with a sliding microtome was facilitated by addition of 10% dibutylphalate to the standard epoxy mixture. The sections were spread on water and attached to coverslips by drying, then heating to 80 C for 1 min. Staining 2 min with 1-3% KMnO₄ and temporary mounting in glycerol on a slide allowed the desired area for electron microscopy to be selected and marked. This area was then cemented to the facet of a conventional epoxy casting with a drop of epoxy resin (without added dibutylphthalate). After polymerization, the coverslip was removed by quick cooling leaving a flat re-embedded portion of the original section. This portion was viewed by transillumination in a dissecting microscope and trimmed of surplus tissue. Ultrathin sections for electron microscopy were obtained in the usual manner.