Volatile Nanoparticle Formation and Growth within a Diluting Diesel Car Exhaust

ABSTRACT

A major source of particle number emissions is road traffic. However, scientific knowledge concerning secondary particle formation and growth of ultrafine particles within vehicle exhaust plumes is still very limited. Volatile nanoparticle formation and subsequent growth conditions were analyzed here to gain a better understanding of “real-world” dilution conditions. Coupled computational fluid dynamics and aerosol microphysics models together with measured size distributions within the exhaust plume of a diesel car were used. The impact of soot particles on nucleation, acting as a condensational sink, and the possible role of low-volatile organic components in growth were assessed. A prescribed reduction of soot particle emissions by 2 orders of magnitude (to capture the effect of a diesel particle filter) resulted in concentrations of nucleation-mode particles within the exhaust plume that were approximately 1 order of magnitude larger. Simulations for simplified sulfuric acid-water vapor gas-oil containing nucleation-mode particles show that the largest particle growth is located in a recirculation zone in the wake of the car. Growth of particles within the vehicle exhaust plume up to detectable size depends crucially on the relationship between the mass rate of gaseous precursor emissions and rapid dilution. Chassis dynamometer measurements indicate that emissions of possible hydrocarbon precursors are significantly enhanced under high engine load conditions and high engine speed. On the basis of results obtained for a diesel passenger car, the contributions from light diesel vehicles to the observed abundance of measured nucleation-mode particles near busy roads might be attributable to the impact of two different time scales: (1) a short one within the plume, marked by sufficient precursor emissions and rapid dilution; and (2) a second and comparatively long time scale resulting from the mix of different precursor sources and the impact of atmospheric chemistry.

IMPLICATIONS

Volatile nucleation-mode particles still dominate curbside size distributions. In contrast to nonvolatile vehicle particle number emission factors, the formation of volatile curbside particle number concentrations depends on processes that cannot be reproduced on vehicle test benches in a reasonably economic way. Greater understanding of formation processes and subsequent growth, chemical composition, and the impact of volatile precursor mix is needed to properly evaluate health effects. An integrated approach is necessary when assessing emissions from different sources and measures.

ACKNOWLEDGMENTS

The German Research Council (DFG WI 1449/8-1-2) funded this project.