Optimisation on machining parametres by EDM of TiN coated Ti6Al4V alloys

ABSTRACT

This study investigated the effects of electro-erosion (EDM) processing parameters on TiN-coated Ti6Al4V alloy by the physical vapour deposition (PVD) technique. Electrode wear rate (TWR), workpiece machining rate (MRR), and surface roughness (Ra) values were determined by including discharge current, pulse time (t_on), and two different tool electrodes (E-Cu and CuBe) into the EDM process parameters. Variables affecting the experimental study (ANOVA) were performed depending on the analysis of variance method. For the analysed (ANOVA) TiN-coated Ti6Al4V samples, the most optimal parameters of MRR value were determined using current 12 A, t_on 100, and Cu electrodes. For the TWR value, the optimum parameters were examined by using current 6 A, t_on 100, and CuBe electrodes. Finally, 12 A current, t_on 100, and electrode E-Cu were analysed for the lowest Ra value. The results showed a better result in MRR and Ra with increasing discharge current, while a better result was obtained in TWR with increasing pulse duration and decreasing discharge current. In addition, it was observed that the E-Cu electrode performed better than the CuBe electrode in processing TiN-coated Ti6Al4V.

KEYWORDS:

• Ti6Al4V
• ANOVA
• pulse on time
• E-Cu and CuBe tool electrodes

Disclosure statement

No potential conflict of interest was reported by the authors.