Integration of geometric variation and part deformation into variation propagation of 3-D assemblies

Abstract

This paper introduces a novel modelling method for variation propagation calculation of 3-D assemblies taking into account geometric variation and part deformation, which are neglected in most models in tolerance analysis. Initially, numerical studies are carried out in order to illustrate the characteristics of strain distribution in components and contact forces on the mating surfaces of a 3-D assembly. According to these characteristics, a linear equivalent model using springs to represent the elastic mating surfaces with geometric variation was presented. Then, the equilibrium criterions corresponding to actual contact situations and iterative searching algorithm of the equilibrium status of contacting were developed. The proposed modelling and calculation method were finally applied to the assembly of two machined parts, on which finite-element analyses and experimental tests were conducted to validate the effectiveness and accuracy. This linear contact model also shows an important advantage on modelling and calculating efficiency, which enable the practical application to variation propagation calculation in both tolerance design and assembly process.

Keywords:

• assembly
• geometric variation
• part deformation
• tolerance analysis

Additional information

Funding

This work was supported by the National Natural Science Foundation of China [grant number 51135004]; National Science and Technology Major Project of China [grant number 2015ZX04005001].