Abstract
Highly concentrated leather dye, i.e., Durapel Black NT removal, was studied using coagulation/flocculation-sand filtration. Eight polymers (6 from polyacrylamide family, polydiallyl dimethyl ammonium chloride (polyDADMAC) and epichlorohydrin-dimethylamine (EpiDMA)); were tested as flocculant aids. Based on the highest dye removal and lowest cost, polydiallyl dimethyl ammonium chloride (polyDADMAC) was found to give the best results. In this study, the difference of Durapel Black NT (DBNT) dye supplies cause the difference in initial absorbance, and a reassessment of several flocculation parameters were carried out again in order to find the optimum parameters. At one hour settling time, the maximum dye removals were about 30–70%. Sufficient times for rapid mixing and polymer injection were found to be important parameters during flocculation. Separation of the flocs was enhanced by the sand filtration. Coagulation/flocculation-sedimentation (4 hours) followed by sand filtration removed about 85% of the dye and a sand size of 0.3–0.6 mm was suitable.
Notes
Note: Conventionally, the low, medium, and high molecular mass consist of <105, 105 − 106 and >106 g/mol respectively. Charge density can be determined using colloid titration. In regard of charge density: low, medium and high charge density polymers have 10%, 25% and 50–100% (mol% of ionic group) (Citation30).
*average of six filtrate, **average of four filtrate because the filtration rate after filtrate no. 4 is less than 0.1 m3/m2 · hr, ***sedimentation time.
NS = not stated, Filtration rate for slow sand filtration: 0.1–0.5 m3/m2 · hr (Citation47).