Validation of radiocarpal joint contact models based on images from a clinical MRI scanner

Abstract

This study was undertaken to assess magnetic resonance imaging (MRI)-based radiocarpal surface contact models of functional loading in a clinical MRI scanner for future in vivo studies, by comparison with experimental measures from three cadaver forearm specimens. Experimental data were acquired using a Tekscan sensor during simulated light grasp. Magnetic resonance (MR) images were used to obtain model geometry and kinematics (image registration). Peak contact pressures (PPs) and average contact pressures (APs), contact forces and contact areas were determined in the radiolunate and radioscaphoid joints. Contact area was also measured directly from MR images acquired with load and compared with model data. Based on the validation criteria (within 25% of experimental data), out of the six articulations (three specimens with two articulations each), two met the criterion for AP (0%, 14%); one for peak pressure (20%); one for contact force (5%); four for contact area with respect to experiment (8%, 13%, 19% and 23%), and three contact areas met the criterion with respect to direct measurements (14%, 21% and 21%). Absolute differences between model and experimental PPs were reasonably low (within 2.5 MPa). Overall, the results indicate that MRI-based models generated from 3T clinical MR scanner appear sufficient to obtain clinically relevant data.

Keywords::

• magnetic resonance imaging
• contact modelling
• validation
• wrist
• radiocarpal joint

Acknowledgements

We would like to acknowledge funding from NIH, Columbia University for the use of Joint_Model software, and Allan Schmitt for technical assistance with MR imaging.

Notes

^1. Email: [email protected]

^2. Email: [email protected]

^3. Email: [email protected]

^4. Email: [email protected]