Experimental investigation of water-in-oil nanoemulsion in sinking electrical discharge machining

ABSTRACT

The most common dielectric in sinking electrical discharge machining (EDM) is kerosene. However, kerosene is inflammable; besides, it can be decomposed and release harmful gases during machining process. And, owing to its low viscosity, using kerosene in sinking EDM has low machining efficiency. Accordingly, conventional sinking EDM using kerosene as dielectric has poor safety, unfriendly environment impact, and low machining efficiency. A new water-in-oil (W/O) nanoemulsion is presented in this paper. This W/O nanoemulsion not only can eliminate the hazards from kerosene to operator and environment but also improve the machining performance of conventional sinking EDM. This research aims to experimentally investigate the machining performance of W/O nanoemulsion in comparison with kerosene in sinking EDM at relatively low discharge energy. The effects of electrode material, electrode polarity, peak current, and pulse duration on machining performance are studied. The machined surface and recast layer of workpiece are characterized as well. The experimental results demonstrate that compared with kerosene, using W/O nanoemulsion in sinking EDM can obtain a higher material removal rate (MRR), a lower relative electrode wear rate (REWR), and a machined workpiece with fewer defects and thinner recast layer.

KEYWORDS:

• EDM
• nanoemulsion
• MRR
• REWR
• graphite
• copper
• SKD61
• SEM
• surface
• dielectric

Additional information

Funding

This work was supported by the the National Natural Science Foundation of China [51774316];the Fundamental Research Funds for the Central Universities [16CX06016A,17CX02058];the Graduate Innovation Project of China University of Petroleum (East China) [YCXJ2016058];the Key Pre-Research Foundation of Military Equipment of China [6140923030702].