Effect of annealing on performance of ZnO thin film transistors

Abstract

ZnO thin film transistors (TFTs) were fabricated through annealing of ZnO thin films at temperatures ranging from 250 °C to 400 °C. ZnO nanoparticles (NPs) synthesized via a sol-gel method were used as an active layer for ZnO TFTs due to their high Hall mobility, and ZnO thin films were produced by spin-coating a precursor solution of ZnO NPs, followed by annealing at 250 °C to 400 °C. When the grain size increases with increasing annealing temperature, the Hall mobility of the ZnO thin films increases due to decrease of the grain boundary density. As the annealing temperature increased from 250 °C to 350 °C, field effect mobility (µ_FE) and on-to-off (I_on/I_off) ratio increased while threshold voltage (V_th) and subthreshold swing (S-S) decreased. This is likely due to an increase in the conductivity of the ZnO thin film according to the increasing grain size. 350 °C-annealed ZnO TFT exhibited the best electrical properties with a V_th of 4.8 V, an I_on/I_off ratio of 10⁴, and a field-effect mobility (μ_FE) of 0.2 cm²V⁻¹s⁻¹.

Keywords:

• thin film transistor
• ZnO nanoparticles
• field-effect mobility
• on-to-off ratio
• threshold voltage

Acknowledgments

This work was supported by the Soonchunhyang University Research Fund and Industrial Human Resources and Skill Development Program (N0001415, Display expert training project for advanced display equipment and component engineer) funded by the Ministry of Trade, Industry & Energy (MOTIE), Korea.

Additional information

Funding

This work was supported by the Soonchunhyang University Research Fund and Industrial Human Resources and Skill Development Program (N0001415, Display expert training project for advanced display equipment and component engineer) funded by the Ministry of Trade, Industry & Energy (MOTIE), Korea