Numerical modelling of tilt casting process for γ-TiAl alloys

Abstract

The tilt casting method is used to achieve tranquil filling of γ-TiAl turbine blades up to 400 mm long. The reactive titanium alloy is induction melted in a cold crucible, and the crucible with the attached mould is then rotated through 180° to transfer the metal into the mould. In the cold crucible, heat losses to the water cooled copper walls and base limit the superheat available, increasing the risk of premature freezing during mould filling. A compromise is required between fast and slow rotations to minimise the casting defects, such as misruns or gas entrainment. Simulations are presented using the authors’ Computational Fluid Dynamics code with several novel developments in front tracking, heat transfer algorithms and turbulence model adaptation, which accounts for an advancing solid front. The computational results are validated against prototype castings produced at the University of Birmingham, and the model is then used to optimise the tilt casting process.

Keywords:

• Tilt casting
• 3D computational model
• γ-TiAl alloys
• Process parameters
• Interface tracking

The authors acknowledge the financial assistance of the EU/IP project IMPRESS (grant no. NMP3-CT-2004-500635) for this research.