Cost analysis of alternative automated technologies for composite parts production

Abstract

Composite material usage in aircraft has been rising since the 1990s, with significant increases in manufacturing productivity and repeatability due to automation in the production of aeronautic parts made of composite materials, becoming a strong driver for widespread adoption of composites in this industry. Automated Tape Layup (ATL) and Automated Fibre Placement (AFP) are two of the most important automated manufacturing technologies within aeronautics composites, although their cost implications and economic comparison have not been widely studied. This paper presents an economic evaluation of ATL and AFP technologies. Using process-based cost models, the manufacturing process of a horizontal stabiliser is modelled, determining for each technology the associated consumption and use of resources and their implications towards the part final cost. Results show that ATL is less expensive than AFP, due to lower material costs, although with less material efficiency and slower cycle time.

Keywords:

• automation
• operational research
• process modelling
• process-based cost modelling (PBCM)
• composites

Disclosure statement

No potential conflict of interest was reported by the authors.

ORCID

B. A. R. Soares http://orcid.org/0000-0003-2737-1154

Additional information

Funding

The authors gratefully acknowledge the funding by Fundação para a Ciência e Tecnologia, FCT, Portugal , under grants [CMUP-ERI/TPE/011/2013] and [MITP-TB/PFM/0005/2013].