Formation of β-iPP in Isotactic Polypropylene/Acrylonitrile–Butadiene–Styrene Blends: Effect of Resin Type, Phase Composition, and Thermal Condition

Abstract

The formation of β-iPP (β-modification of isotactic polypropylene) in the iPP/ABS (acrylonitrile–butadiene–styrene), iPP/styrene–butadiene (K resin), and iPP/styrene–acrylonitrile (SAN) blends were studied using differential scanning calorimery (DSC), wide angle X-ray diffraction (WAXD), and scanning electron microscopy (SEM). It was found that α-iPP (α-modification of isotactic polypropylene) and β-iPP can simultaneously form in the iPP/ABS blend, whereas only α-iPP exists in the iPP/K resin and iPP/SAN blend samples. The effects of phase composition and thermal conditions on the β-iPP formation in the iPP/ABS blends were also investigated. The results showed that when the ABS content was low, the ABS dispersed phase distributed in the iPP continuous phase, facilitating the growth of β-iPP, and the maximum amount of β-iPP occurred when the composition of iPP/ABS blend approached 80:20 by weight. Furthermore, it was found that the iPP/ABS blend showed an upper critical temperature T _c * at 130°C for the formation of β-iPP. When the crystallization temperature was higher than the T _c *, the β-iPP did not form. Interestingly, the iPP/ABS blend did not demonstrate the lower critical temperature T _c ** previously reported for pure iPP and its blends. Even if the crystallization temperature decreased to 90°C, there was still β-iPP generation, indicating that ABS has a strong ability to induce the β-iPP. However, the annealing experiments results revealed that annealing in the melt state could eliminate the susceptibility to β-crystallization of iPP.

Keywords:

• ABS
• blends
• crystallization
• β-iPP
• phase composition
• polypropylene

Acknowledgment

The study was supported by the Foundation of Hunan Educational Committee (no. 09C957).