Abstract
This experimental study focuses on generation and control of annular impinging jets. The annular nozzle used in the investigations was designed with an active flow control system using 12 synthetic jets issuing radially from the central nozzle body. Measurements of the control effects were made on the impingement wall. The data acquisition involved wall pressure and wall mass transfer (by the naphthalene sublimation technique) using air as the working fluid. Also measured was time-mean flow velocity (by a Pitot probe) in the jet flow field. Moreover, flow visualization was carried out. Two main flow-field patterns (A and B) were identified. The patterns differ in the size of the separated-flow recirculation regions that develop attached to the nozzle central body: While pattern A is characterized by a quite small recirculation region (bubble) extending not far from the nozzle exit, pattern B exhibits a large recirculation region, reaching up to the impingement wall, on which it forms a stagnation circle. The control action modifies the flow field, resulting in changes of the corresponding heat/mass transfer distributions. The convective transfer rate on the stagnation circle can be demonstrably enhanced by 20% at a moderate nozzle-to-wall distance, equal to 0.6 of the nozzle outer diameter.