The influence of an applied DC electric field on viscosity and droplet size distribution of different water‐in‐crude oil emulsions was monitored in order to investigate the induction of coalescence of the water droplets. The effects caused by the voltage imposition were studied by rheological analysis and the validity of the obtained results was discussed, comparing with the features of real electrocoalcscer systems. A low field NMR technique (CPMG NMR) and digital video microscopy (DVM) were used to elucidate the behavior of the emulsions. Experiments performed at low shear rate with increasing electric field magnitude showed an increase in viscosity until a critical value. ECRIT was reached. Thereafter coalescence occurred and viscosity decreased irreversibly below its initial value. The electrorheological behavior of the emulsions can be attributed to the organization (flocculation) of water droplets induced by the electric field, accompanied by an increase in viscosity. The structure breaks down as the shear rate is increased, leading to a decrease in viscosity. Experiments performed at high shear showed only a small decline in the viscosity. Although it was evident that coalescence took place, it did not involve the whole sample, because the electrodes were uncoated. As a direct consequence, the mean value of the droplet size within the emulsion did not change noticeably. Nonetheless this mean value was less recurrent and the formation of droplets of very large diameter occurred.
We gratefully acknowledge support from the Electrocoalescence II project by NFR (Norwegian Research Council) and industry partners. We also thank Helene Magnusson and Sébastien Simon for helpful discussions on interpretation of rheological results and other useful advices.