Geology and geochemistry of fault-hosted hydrothermal and sedimentary manganese deposits in the Oakover Basin, east Pilbara, Western Australia

ABSTRACT

Manganese mineralisation in the Oakover Basin is associated with Mesoproterozoic extension, basin formation and deposition of the Manganese Group. The underlying basement architecture of the Oakover Basin (a local half-graben geometry), inherited from the Neoarchean rifting event, plays an important role on the distribution, style and timing of manganese deposits. Fault-hosted manganese deposits are dominant along the ‘active’ faulted eastern margin, whereas flat-lying sedimentary deposits are dominant along the western ‘passive’ margin reflecting differences in ore-forming processes. The large number of significant manganese deposits in the Oakover Basin, previously thought to reflect a spatial association with Carawine Dolomite, more likely reflects the restricted nature of the Mesoproterozoic basin and development of a large reservoir of Mn²⁺ and Fe²⁺ in an anoxic zone of a stratified basin. Low O₂ conditions in the basin were caused by a paleotopographic high forming a barrier to open ocean circulation. The western margin sedimentary deposits formed later than the fault-hosted hydrothermal deposits along the eastern margin, once a significant reservoir of Mn²⁺ and Fe²⁺ had developed, and when there was sufficient subsidence to allow migration of the redox front onto the shallow shelf, with Mn precipitation on and within the seafloor sediments. The sedimentary manganese deposits are not uniformly distributed along the western edge of the basin; instead they are concentrated into discrete areas (e.g. Mt Cooke–Utah–Mt Rove, Bee Hill, Skull Springs and the Ripon Hills districts), suggesting a degree of structural control on their distribution. Fault-hosted manganese is observed beneath and adjacent to many of the sedimentary deposits. Marked geochemical differences are observed between the Woodie Woodie hydrothermal deposits and the sedimentary deposits. Woodie Woodie deposits display higher Ba, U, Mo, As, Sn, Bi, Pb, S and Cu than the sedimentary deposits, reflecting the composition of the hydrothermal fluids. The Al₂O₃ values of the Ripon Hills and Mt Cooke deposits are much higher than the Woodie Woodie deposits, reflecting the composition of the dominant host rock, as Al₂O₃ is typically <5 wt% in the Carawine Dolomite, but is >10 wt% in basal shale units of the Manganese Group. Highly variable Mn:Fe ratios (≫5:1) in the hydrothermal manganese at Woodie Woodie reflects rapid deposition of Mn in and around fault zones. In contrast, slower accumulation of Mn oxides on and within the seafloor to form the large sedimentary deposits results in Mn:Fe ratios closer to 1:1 and elevated Co + Ni and REE values.

KEYWORDS:

• Sedimentary manganese
• hydrothermal manganese
• East Pilbara
• geochemistry
• structure
• Mesoproterozoic

Acknowledgements

First, thanks to Consolidated Minerals Australia Ltd for allowing me to publish this research. I would like to thank the CMA exploration and mine geologists for the numerous discussions, field trips and help with this research over the last 9 years. I would also like to thank Joe Drake-Brockman for his detailed geological mapping of the Woodie Woodie mine corridor. Thanks to Tim Blake for an introduction to the Woodie Woodie geology in 2007, his regional mapping and work on the origin of the manganese deposits (a large part of this work is published in Blake et al., 2011). Thanks to the two anonymous reviewers who made some great suggestions for the manuscript.

Disclosure statement

No potential conflict of interest was reported by the author.