Conditioning film formation and its influence on the initial adhesion and biofilm formation by a cyanobacterium on photobioreactor materials

Abstract

Although cyanobacteria are a common group of microorganisms well-suited to utilization in photobioreactors (PBRs), studies of cyanobacteria fouling and its prevention are scarce. Using a cyanobacterium, Anabaena sp. PCC 7120, which had been genetically modified to enhance linalool production, the formation of conditioning films and the effects of these on the physico-chemical surface properties of various PBR materials during initial adhesion and biofilm formation were investigated. The adhesion assay revealed that the overall attachment of Anabaena was substratum dependent and no correlation between the hydrophobicity/roughness of clean material and cell attachment was found. Surface hydrophilicity/hydrophobicity of all the materials changed within 12 h due to formation of conditioning films. ATR-FTIR spectroscopy revealed that the fractional change in protein deposition between 12 to 96 h was consistent with Anabaena cell attachment but polysaccharide deposition was material specific and did not correlate with cell attachment on the PBR materials. Also, the delay in conditioning film proteins on PVC and PTFE indicated that components other than proteins may be responsible for the decrease in contact angles on these surfaces within 12 h. This indicates the important role of the chemical nature of adsorbed conditioning films in determining the initial attachment of Anabaena to PBR materials. The lower rate of attachment of Anabaena on the hydrophilic surfaces (glass and PMMA) between 72 h to 96 h (regime 3) showed that these surfaces could potentially have low fouling characteristics at extended time scales and should be considered for further research.

Keywords:

• Biofouling
• photobioreactor
• biofilm
• conditioning film
• adhesion mechanism
• cyanobacteria

Disclosure statement

No potential conflict of interest was reported by the author(s).

Additional information

Funding

This work was financially supported by the National Aeronautics and Space Administration (NASA) under Grant [number NNX11AM03A], the Department of Chemical and Biological Engineering (CBE) at South Dakota School of Mines and Technology and the Composites and the Polymer Engineering (CAPE) Laboratory at South Dakota School of Mines and Technology and these organizations are greatly acknowledged by the authors.