![Sample our Engineering & Technology journals, sign in here to start your access, latest two full volumes FREE to you for 14 days]({"type":"image" , "src" : "/sda/5933/TOC-Subject-Sample-2021-Engineering-Tech.jpg"})
Abstract
It is well known that weld residual stress and distortion should be controlled appropriately for structural integrity. Recently, it has become much more necessary to control weld distortion to highly improve manufacturing efficiency. Various studies on control of weld distortion had been conducted based on clarification of influential dominant factors for that. The influential dominant factors had been studied from a viewpoint of temperature distribution in plate thickness section. Without considering moving the weld heat source, the temperature distribution is controlled by weld heat input (Qnet) per weld length. Angular distortion, which is controlled by temperature distribution along the direction of plate thickness (h), is controlled by heat input parameter (Qnet/h2). However, it has recently become known that the conventional results cannot be applied to all welding processes because such processes are becoming more diversified. It is significant for more accurate control of angular distortion to investigate once again the relationship between the heat input parameter and angular distortion. In this study, a series of experiments on the relationship between heat input parameter and angular distortion are carried out. The effects of welding current and welding speed are investigated individually in both TIG and MAG welding. The difference between these welding methods is also investigated. Based on the result, the effects of them are discussed in relation to temperature distribution during welding. It is considered that angular distortion is affected by temperature distribution not only in plate thickness section but also along welding direction. So, angular distortion is not always controlled by only the conventional heat input parameter because the heat input parameter is proposed as the influential dominant factor for temperature distribution in plate thickness section. It is concluded that generation characteristics of inherent strain should be considered in relation to three-dimensional temperature distributions during welding for more accurate control of angular distortion.
Acknowledgements
Professor Murakawa Hidekazu of the Welding and Joining Institute, Osaka University and Professor Terasaki Toshio of Kyushu Industrial University provided valuable advice during our examination of the results of this study and we would like to express our appreciation of this.
Notes
Presented at the 2007 Autumn National Conference of the Japan Society of Welding.