Method to determine the dosage of bituminous tack coat in function of the texture of milled asphalt layers to be overlaid

ABSTRACT

In the rehabilitation of flexible pavements with asphalt layers, it is necessary to apply a bituminous tack coat with a pre-established dosage, which usually does not take into account the degree of texture generated if a milling operation is previously performed since this increases the surface at the interface. On the other hand, when milling, grooves are obtained that could lead to the runoff of bitumen emulsion with excessive deposition in their valleys due to dosages greater than those needed. This work analyses the above mentioned and achieves a compromise solution, with its corresponding method of application, based on the mechanical behaviour obtained with different degrees of texture and validated for typical materials used in Argentina.

KEYWORDS:

• Road engineering
• asphalt Overlays
• pavement milling
• bituminous tack coat

Disclosure statement

No potential conflict of interest was reported by the authors.

Additional information

Funding

This work was supported by Argentine Ministry of Education [grant number IFI4708TC].