An Investigation into Lubrication and Oxide Breakdown During Load-Carrying Capacity Testing

Abstract

Changes occurring in the friction and wear mechanisms during a load-carrying capacity test, lubricated with cetane containing a carboxylic acid, were investigated. The changes in wear scar/track appearance and oxide coverage/composition were analyzed during every load stage.

The main conclusions were as follows:

• The breakdown in the protective oxide layer formed on the opposing steel surfaces was found to be the prerequisite for initiation of seizure.

• The seizure load achieved during load-carrying capacity testing quantifies the ability of the test fluid to prevent transition to the adhesive wear regime.

• The most severe surface damage was found to occur during the first few seconds after test initiation. Desorption of the adsorbed lubricant film and the subsequent removal of the naturally occurring thin oxide layer results in the initial period of adhesive wear.

• Partial recovery to a state of acceptable friction occurs after the period of initial seizure. During this period, the surface coverage by the adsorption lubricant molecules and the oxide coverage are sufficient to prevent severe adhesive wear from occurring. Wear is primarily a combination of oxidative, abrasive, and fatigue wear (all possible in the regions of mixed friction and boundary lubrication).

• Final lubricant breakdown and eventual seizure are initiated when the oxide removal rate exceeds the oxide formation rate resulting in severe adhesive wear followed by seizure.

KEY WORDS:

• SRV Machine
• Load-Carrying Capacity
• Oxide Layer