Transient heat flux measurement analysis from coaxial thermocouples at convective based step heat load

Abstract

The measurement of surface heating rate is an imperative parameter in the force convection ground-based facility for short duration investigation due to the heat transfer rate is changing rapidly. The coaxial thermocouples are suitable to measure the transient heat flux in fast varying heat transfer application because of having fast response time in the range microseconds or less. In this addition, the K-type, E-type, and J-type of coaxial thermocouples are contrived as well as the thermal coefficient resistance (TCR) and sensitivity (S) has been calculated from oil-bath based technique. These handmade coaxial thermocouples are exposed in a forced convection flow facility having three different input step heat loads as well as their transient heat fluxes are estimated using one-dimensional heat conduction modeling for the semi-infinite body. The numerical simulation has also been carried out with the analogous experimental parameters using ANSYS-FLUENT v.15.0 and compared with the outcome of the experimental approach and it is found that the average value of the transient temperatures having 0.3% error and surface heat flux recovered from this temperature is 10%. This study reveals the measuring ability of these handmade coaxial thermocouples at low temperature and low velocity on short duration transient measurements.